Yacht Devices Battery Monitor for SeatalkNG - YDBM-02R

Yacht Devices Battery Monitor for SeatalkNG - YDBM-02R

This Version is supplied with a Raymarine SeatalkNG Compatible connector for direct connection into a SeatalkNG T-Piece or 5 way connector block

The device reports measured voltage and current, calculated health and charge state, and user programmed static data (e.g. nominal capacity and chemistry) to NMEA 2000 and can turn on the genset or warn when the battery state is critical.

The Battery Monitor can be used with any single DC source (i.e. alternator, wind generator, etc.) or load (windlass, refrigerator, etc.), but it is primarily designed for monitoring a vessel's battery. To operate as intended, it requires an appropriate external shunt (not supplied with the Device); shunts in the range from 5A to 1200A are widely available (please refer to Section V "Choosing a Shunt" of the User Manual). It can be configured to use data from a NMEA 2000 thermometer connected to the battery to detect the charge state and health more accurately and report temperature along with voltage and current data.

The Device incorporates a MicroSD card slot which allows using a standard FAT-formatted card to configure it and update its firmware. At minimum, you should specify drop voltage and maximum current for the connected shunt. In addition, you can specify battery parameters such as nominal capacity and voltage, chemistry, etc. The Device can be also configured over NMEA 2000 using installation description strings; a PC gateway and software (like CAN Log Viewer or ActiSense NMEA Reader) may be required for this method.

Unlike the previous model YDBM-01, the YDBM-02 model has an extra wire and can be used with a shunt connected to either the positive or negative batery terminal. It is the only difference between the models, the YDBM-02 can be used to replace the previous model in all possible cases.

The Battery Monitor can be configured to manage channels of an NMEA 2000 digital switching system, and/or trigger a digital alarm unit compatible with standard NMEA 2000 PGNs 127501/127502. For example, you can configure the Battery Monitor to automatically raise a sound or voice alert about low battery charge with the Alarm Button, or to turn some equipment on or off, or to start a genset to recharge the battery with the Circuit Control.

Electrical characteristics:

External shunt rated current: 5..2500 A

External shunt's nominal voltage drop (recommended): 75 mV

Current measurement accuracy (see note below): ±0.5 %

Maximum allowed DC voltage on inputs (with respect to GND input): 40 V

Voltage measurement accuracy: 0.1 V

Breakdown voltage between NMEA 2000 network interface and inputs: 2500 VRMS

Note: the number do not account for shunt accuracy which is typically ±0.25% or ±0.5%, and ±20..25 ppm/°C for temperature drift.